Today I removed the rubber floor mats and blew all the dirt off of the chassis. Blasted the chassis off with a pressure washer, trying to remove all of the dirt and grease, which didn't work as well as i'd hoped. But I was able to get a lot of the dirt and grease off so I could start removing the tar board soundproofing from the floors. I would suggest using a heated pressure washer if you're going to go this route. As I planned on sandblasting the chassis anyway, this wasn't that big a deal.
The pressure washer did a decent job of making it easier to remove some of the tar board, but I'll have to go after the rest with a putty knife.
No comments:
Post a Comment